The NSR1050H is an entrance model of the NSR1000 series recording servers, with physical storage capacity of 500GB. The key concepts of the NSR1050H are a “hybrid” capability – supporting both legacy analog and current IP cameras, and both Full HD/SD cameras/displays – an open-platform design, and ease of setup and operation. The NSR1050H supports 16 units of analog cameras without any adaptors. The NSR1050H supports up to 20 units of IP/analog cameras in total. The NSR1050H can be also used with up to seven units of the NSRE-S200 (2 TB Hard Disk Storage Device), allowing for the addition of 14GB storage capacity. With the NSR1050H, you can open the door to a world of new possibilities in video surveillance.

• * Model Number - NSR1050H
• * Number of Cameras Supported (IP/Analog Total) - Max. 20
• * Analog Camera Input - 16ch Video Input/ 4ch Audio Input (Supplied Cable)
• * Video Compression (IP-Camera) - MPEG-4 or JPEG
• * Video Compression (Analog-Camera) - MPEG-4
• * Maximum Recording Rate - 120 fps
• * Hard Disk Drives (Physical Capacity) - 500 GB (500 GB x1)
• * Hard Disk Drives (RAID Level) - n/a
• * Hard Disk Drives (Recording Capacity) - 443 GB
• * Expansion Storage - Supports NSRE-S200 (2000 GB) (Max. 7 Units)
• * Monitor Out #1 - HDMI (A-type) x1, D-sub 15pin x1 (Front) or D-sub 15pin x1 (Rear).
• * Monitor Out #2 - HDMI (A-type) x1, D-sub 15pin x1.
• * Line Out - RCA-pin, L/R x1 stereo pair
• * Sensor In - 8-channel photo-coupler (DC3.3-24 V)
• * Alarm Out - 8-channel relay (Max. 24 V 1 A)
• * Ethernet - 1000Base-T/100Base-TX/10Base-T x 4 (Auto switching)
• * USB 2.0 - x3 (Front), x3 (Rear)
• * Serial Interface (for UPS) - RS-232C x1
• * Serial Interface (for Analog Camera Control) - RS-232C x1, RS-422/485 x1 (Either one to be selected)
• * SAS 1.1 (Serial Attached SCSI) - SFF-8088 type x1
• * Dimensions (W x H x D) - 17 x 3 1/2 x 16 1/2 inches (430 mm x 87 mm x 417 mm) (exclusive projections)
• * Weight - Approx. 25 lb 6 oz (11.5 kg)
• * Power Requirements - 100 V to 127 V/200 V to 240 V AC (50/60 Hz)
• * Power Consumption - 175 W (typical)
• * Operating Temperature - 41 to 104 ºF (5 to 40 ºC)
• * Operating Humidity - 10 to 80% (Max. wet-bulb temperature 30 °C, non-condensing)
• * Supplied Accessories - Analog Camera Cable x1 (NSR-1050H Only), Front panel key x2, Rubber Feet x4, Recovery CD x1, Manual/Tool/Source Codes CD x1